High Voltage Pulse Matched Resistive Power Dividers

Barth High Voltage Resistive Power Dividers are matched impedance coaxial devices for use primarily in pulsed 50 ohm systems, or where occasional transients would damage ordinary units. These units are ideal for use in nuclear and high energy experiments. These dividers feature input and output impedance very close to 50 ohms. Extensive testing during manufacturing insures very high reliability for single-shot experiments. A voltage coefficient of the resistive film of less than .0001%/V allows low voltage calibration of most systems.

ADVANTAGES OVER STANDARD RF POWER DIVIDERS

  • Withstands High Voltage Pulses
  • Low Voltage Coefficient
  • Input/Output impedance held very close to nominal
  • Low Reflection Coefficient
  • High Reliability
  • Pulse Power Rated

Power Divider Selection

Matched Resistive Power Dividers

9 Port & 100 Port Dividers

Maximum Input Limitations

The voltage specification of our products is sometimes limited by the breakdown characteristics; read the complete explanation, by clicking below...
Please read

Print Friendly